Levelone WCS-2060 Bedienungsanleitung PDF herunterladen (Seite 11)

For more detailed usage of the Installation Wizard, please refer to the user manual of

the Installation Wizard included in the product CDROM to find the location of the

Network Camera. There may be many Network Cameras in the local network. Users

can differentiate the Network Cameras with the MAC address. The MAC address is

printed on the back of the Network Camera body. Initial Access to the Network Camera

Check Network Settings

FCS-1060/WCS-2060 IP Network Camera can be connected either before or immediately after

software installation onto the Local Area Network. The Administrator should complete the network

settings on the configuration page, including the correct subnet mask and IP address of gateway

and DNS. Ask your network administrator or Internet service provider for the detail information. By

default the Network Camera requires the Administrator to run installation every time it reboots. If

the network settings are to remain unchanged, disable the Install option. Refer to “Network

settings” on the System Configuration page for details. If any setting is entered incorrectly and

cannot proceed to setting up the Network Camera, restore the factory settings following the steps

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 74 75

Keine Kommentare

Levelone WCS-2060 Bedienungsanleitung Seite 11