LevelOne WAP-6101 Bedienungsanleitung PDF herunterladen (Seite 15)

WPA-6101 300Mbps Wireless Ceiling Gigabit PoE Access Point

Configure Slave AP via WEC Button

Step 1

Check WiFi LED of Access Point which acts as Master Mode.

(Press Reset/WEC button 5~10 sec then release Button to change Mode .When System

is ready Status LED in Solid : It is in Master Mode)

Step 2

Check WiFi LED of Access Point which acts as Slave Mode.

(Press Reset/WEC button 5~10 sec then release Button to change Mode .When System

is ready Status LED in Flash : It is in Slave Mode)

Step 3

Click WEC Button (about 1second) of master AP and any slave AP as one pair

simultaneously

Step 4

WiFi LED of Master and Slave AP will flash and Negotiate WiFi Profile Configuration. This

Process will finish within 20~30 sec.

Then Check WiFi LED:

LED in Slow flash: Wireless Connection doesn't establish.

LED in Solid : Wireless Connection established successfully.

※If Negotiation failed or Master or Slave AP don’t existed, WiFi LED will Flash 2 min.

Please try again.

※WEC Application bases on WiFi WPS Technology and only supports to use

“AES” encryption to negotiate, currently. Please notify before configuring AP in

Master Mode.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 48 49

Keine Kommentare

LevelOne WAP-6101 Bedienungsanleitung Seite 15