LevelOne WBR-6012 Bedienungsanleitung PDF herunterladen (Seite 76)

Whatever I setup, the pc can not get ip. Please check Status Led and refer to the Q2:

2.Why can I not connect the router even if the cable is plugged in Lan

port and the led is light?

A: First, please check Status Led. If the device is normal, the led will blink per second.

If not, please check How blinking Status led shows.

There are many abnormal symptoms as below:

Status Led is bright or dark in work: The system hanged up .Suggest powering off and on

the router. But this symptom often occurs, please reset to default or upgrade latest fw to try

again.

Status led flashes irregularly: Maybe the root cause is Flash rom and please press reset

Button to reset to default or try to use Recovery mode.(Refer to Q3 and Q4)

Status flashes very fast while powering on: Maybe the router is the recovery mode and

please refer to Q4.

3.How to reset to factory default?

A: Press Wireless on /off and WPS button simultaneously about 5 sec

Status will start flashing about 5 times, remove the finger. The RESTORE process is

completed.

4.Why can I not connect Internet even though the cables are plugged in

Wan port and Lan port and the leds are blink. In addition, Status led is

also normal and I can configure web management?

A: Make sure that the network cable from DSL or Cable modem is plugged in Wan port of

Router and that the network cable from Lan port of router is plugged in Ethernet adapter. Then,

please check which wan type you use. If you are not sure, please call the isp. Then please go

to this page to input the information isp is assigned.

1 2 ... 71 72 73 74 75 76 77 78 79

Keine Kommentare

LevelOne WBR-6012 Bedienungsanleitung Seite 76