Levelone WBR-6003 Bedienungsanleitung PDF herunterladen (Seite 62)

Routing

When you have more than one WBR-6003, or router with different subnets on the network, you will

need to enable this function to allow the different subnets to communicate with each other.

There are two types of routing supported by the WBR-6003.

• Dynamic Routing: This method uses Routing Information Protocol (RIP) to enable the

devices to determine the best route for each packet based on the number of hops between the

source and destination.

Tick the Enable box to enable Dynamic Routing. Use RIPv2 only if you have different subnets

in your network. Otherwise, please select RIPv1 if you need this protocol.

• Static Routing: Allows computers that are connected to the WBR-6003 to communicate with

computers on other LAN segments which are connected to the WBR-6003 using a different

router. You can specify up to eight routing rules.

The details below are required to set the routing rules:

 IP Address

 Subnet Mask

 Gateway

 Hop, number of hops

 Tick Enable for each rule.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 79 80

Keine Kommentare

Levelone WBR-6003 Bedienungsanleitung Seite 62