LevelOne IFE-0500 4-Port PoE + 1-Port TP Industrial Fast Ethernet Switch User Manual Ver. 1.0.0-0711 1
Straight Through Cable Schematic Cross Over Cable Schematic 10
Cabling Twisted-pair segment can be connected with unshielded twisted pair (UTP) or shielded twisted pair (STP) cable. The cable must comply with t
Wiring the Power Inputs Please follow the steps below to insert the power wire. Insert the positive and negative wires into the V+ and V- contacts
Wiring the Fault Alarm Contact The fault alarm contact is in the middle of terminal block connector as the picture shows below. When the wires are in
Mounting Installation DIN-Rail Mounting The DIN-Rail is screwed on the industrial switch when out of factory. If the DIN-Rail is not screwed on the
4. Then, lightly push the DIN-Rail into the track. 5. Check if the DIN-Rail is tightened on the track or not. 6. To remove the industrial swit
Wall Mount Plate Mounting 1. Follow the steps below to mount the industrial switch with wall mount plate. 2. Remove the DIN-Rail from the industria
Hardware Installation In this paragraph, we are going to mention how to install the 4-Port PoE + 1-Port TP Industrial Fast Ethernet Switch and the ins
Network Application This segment provides the sample to help user have more actual idea of industrial switch application. For a sample application of
Troubleshooting Verify that is using the right power cord/adapter (DC 48V), please don’t use the power adapter with DC output voltage higher than
FCC Warning This Equipment has been tested and found to comply with the limits for a Class-A digital device, pursuant to Part 15 of the FCC rules. The
Technical Specification The IFE-0500 4-Port PoE + 1-Port TP Industrial Fast Ethernet Switch technical specifications is shown as below. IFE-0500 4-
Power Consumption 3.4Watts (without PoE); 57 Watts (Full load with PoE) Installation DIN rail kit for DIN-type cabinet install and wall-mount ear for
Content INTRODUCTION...4 FEATURES...
Introduction The 4-Port PoE + 1-Port TP Industrial Fast Ethernet Switch is a cost-effective solution and meets the high reliability requirements deman
Package Contents Please refer to the package contents list below to verify them against the checklist. IFE-0500 CD Manual Pluggable Terminal B
Hardware Description In this paragraph, the Industrial switch’s hardware spec, port, cabling information, and wiring installation will be described.
Top View The top view of the 4-Port PoE + 1-Port TP Industrial Fast Ethernet Switch has one terminal block connector of two DC power inputs. Top
LED Indicators The diagnostic LEDs located on the front panel of the industrial switch provide real-time information of system and optional status. T
Ports RJ-45 ports The UTP (RJ-45) Fast Ethernet ports will auto-sense for 10Base-T or 100Base-TX connections. Auto MDI/MDIX means that the switch
Kommentare zu diesen Handbüchern